How to properly load a dishwasher:

Loading a dishwasher is not difficult, but loading it properly can help your dishes come out cleaner. It can also save energy and time.

1. Scrape the large food items off of dishes and into the trash or garbage disposal. Definitely remove things like bones, corncobs, seeds, and peelings, etc. The fork or paper napkin used when eating should be enough to get the large particles off, but if you have a lot to do, a brush or rubber spatula can help, too.

2. Smaller particles, like grains of rice, may or may not come off in your dishwasher. If your clean dishes come out with the occasional grain of rice stuck to them, you can remove it after the fact and make a point to do a better job of scraping next time.

3. Pre-rinse, but only if it is necessary. Not all dishwashers require that dishes be rinsed before loading. Some dishwashers and dishwasher detergents actually do a better job if they have something to remove. If your dishes aren’t coming out clean, though, try doing a better job of pre-rinsing. It’s easiest to pre-rinse immediately after you’ve used a dish, before food dries on and hardens.

4. Use warm, soapy water and a scrub brush when necessary to remove stuck on food. Again, do this only if your dishwasher seems to need it. Dishwashers really do wash dishes.

5. Learn as you use your dishwasher what generally comes off and what does not. Proteins such as eggs and cheese; cooked- or baked-on foods; and starches that have dried onto the dish often require extra attention. Fill these items with warm, soapy water and let them soak before placing them in the dishwasher.

6. The dishwasher detergent can make as much difference as to how much pre-rinsing you have to do as the dishwasher, and it’s the easier thing to replace. Read reviews or simply try other brands when you run out to find one that works best for you.

7. Insert the plates into the slots in the bottom section of the dishwasher. Face them toward the center and, if they lean at all, lean them inwards and downwards. Try to keep all surfaces separated and accessible to the stream of water from the sprayers.

8. Place the cups, glasses, and bowls in the top section of the dishwasher. Stack the bowls neatly on an incline, so that the washing solution can reach inside the bowl and so that they will drain.

9. Place Tupperware and other plastic items on the top rack. Because the heating element in most dishwashers is on the bottom, placing plastic items in the bottom rack could cause them to melt or warp.

10. Place the various pots and pans open-side down in the bottom section of the dishwasher.

11. Place utensils with handles down in the utensil baskets in the bottom section of the dishwasher.

12. Lay larger serving utensils horizontally across the top section of the dishwasher. Arrange serving spoons with the bowl facing down so that water does not collect in them. Don’t wash good cooking knives in the dishwasher. Sharp knives are often dulled by the washing cycle by rubbing against other items. Wash good knives by hand, especially if they have wooden handles.

13. Mix up different kinds of utensils in the utensil baskets to prevent several of the same item from nesting in one another and blocking the water.

14. Place cutting boards on the very outside of the bottom section of the dishwasher if they will not fit in the slots designated for plates.

15. Fill the soap container on the bottom section of the dishwasher or the dishwasher door with powdered dishwasher detergent. Fill to the designated line. If you use pellet-style detergent, simply use one pellet. Fill the soap container with the door, first. It is timed to open after the dishwasher does some pre-rinsing to soften up the dirt on its own.

16. Filling the second soap container (often an open one) may not be necessary. The dishwasher manufacturer and detergent companies usually recommend it, but if your results are satisfactory without it, save yourself the extra detergent. Or, fill the second cup only if the dishes are very dirty. Try it both ways.

17. If your dishwasher has a feature for a rinse agent such as “Jet-Dry” or vinegar, fill with rinse agent to designated line. This will help to reduce water spots, especially if you have hard water. The rinse aid may not need refilling every time you run the dishwasher, but do top it off every couple of weeks to a month, or according to the instruction manual. Some dishwasher detergent has rinse aid in it. Read the label. If you have a water softener, or if your water is reasonably soft to begin with, you may find that rinse aid is unnecessary.

18. Make sure breakables do not touch each other, since the dishes can vibrate during the washing cycles.

19. Check before each run that spinning arms can spin freely and that there is nothing obstructing tubes or sprayers. Also, make sure that the detergent cups can open fully.

20. Run the garbage disposal before running your dishwasher. Dishwashers often drain into the same pipe as the sink, so it’s important that the pipe be clear. If you don’t have a garbage disposal, use a strainer in the sink drain to stop crumbs and debris from accumulating in the pipe.

21. Run hot water into your sink until the water coming out of the tap is hot. Dishwashers can heat up the water somewhat, but they usually work best when the water starts hot. If water is scarce, run the water into a container and use it to water plants.

22. Close the door to the dishwasher and start the dishwasher, using the instructions for your particular dishwasher. Generally, you must select a cycle and fully close and latch the door.

Tips:

• Some dishwasher models don’t have sprayers or arms under the top rack. If your dishwasher doesn’t seem to get the inside of your glasses and other items on the top rack clean, see if large items in the lower rack are blocking most the water from the arm under the bottom rack. Water goes through the plates much easier than a large pot or bowl.
• Place similar-sized dishware near each other for easy unloading.
• Store powdered detergents in a dry place until they are ready for use.
• Make sure your water starts hot enough. Set the thermostat on your water heater to 120F ^[1]. Water that is cooler than this won’t do a good job cleaning. Water that is hotter could scald.
• For energy efficiency run the shortest cycle that effectively cleans your dishes. “Pot-scrubber” and heavy-duty cycles need only be used with the dirtiest dish loads. Run full (but not over-full) loads.
• Choose the air dry cycle to save energy. If your dishes aren’t perfectly dry at the end of the cycle, leave the door open or partly open for a while before you unload.
• Make sure your water heater is at the right temperature, generally about 120F. Water too hot wastes energy while water that is not hot enough will not clean dishes well.
• Load the dishwasher as you go. Get in the habit of setting your dish down in the dishwasher, instead of the sink.
• Run full loads. Running a full load in your dishwasher can save water compared to washing dishes by hand, especially if you don’t overdo it on the pre-rinsing.
• Unload the dishwasher promptly after running it or as soon as is convenient so there’s no excuse for stacking dirty dishes in the sink.
• For best cleaning, utensils should be placed in the basket handle down (that’s how restaurants do it).

• Is there water involved? If you are getting your dishwasher, ice maker, washing machine, or refrigerator’s ice maker repaired, get out some old towels to soak up the water.

• Do you have a pet? Make sure that the area is cleared of all traces of the pet before the technician comes in. If the servicing technician is allergic to animal dander, they cannot physically work on your appliance.

• If you have a bug or rodent infestation, make sure you get that handled before you call an appliance repair company, or even your warranty company.

• Make sure you will have someone there over the age of 18. We cannot enter the premesis without an adult present.

Whether you are looking for Appliance Repair in Scottsdale, or Appliance Repair in Phoenix, or anywhere else in the valley, give us a call, we do it all. Many brands under warranty, all brands out of warranty!

ASKO Dishwasher Recall
Another appliance manufacturer is recalling some of their dishwashers.
This time it’s ASKO, a swedish manufacturer that is known for their dishwashers, washers and dryers.
About 130,000 dishwashers are being recalled due to a fire hazard:
An electrical component in the dishwasher can overheat, posing a fire hazard to consumers.
The 21 reported dishwasher fire cases caused product and property damages, but no injuries have been reported.
The recalled dishwashers include the ASKO DW95 model series with model numbers 1355, 1375, 1385, 1475, 1485, 1555, 1585, 1595, 1655, 1805, 1885, and 1895 that were manufacturered from January 1995 through April 2000 and sold at appliance stores for about $750 – $1300.

The remedy is as always:
Consumers should stop using the dishwashers immediately and contact Asko to arrange for a free inspection and repair or to participate in a rebate program.

Contact us at 623-780-1629 or call Asko toll-free at (866) 309-9921 between 10 a.m. and 7 p.m. CT Monday through Friday, or visit their Web site at www.askousa.com

Units: About 35,000

Distributor: Frigidaire, of Cleveland, Ohio

Hazard: An internal defect in the washer’s drain pump can cause heat to build up, posing a fire hazard to the consumer.

Incidents/Injuries: No incidents or injuries have been reported.

Description: This recall involves the Crosley®, Frigidaire®, Kelvinator®, Kenmore®, Wascomat®, and White-Westinghouse® top load washers, 3.1 cubic foot front load washers and laundry centers.

Product Type Brand Model Serial Number
Top Load Washer Crosley, Frigidaire, Kelvinator,
White- Westinghouse
CTW100FW GLWS1749FS SWS833HS
FTW3011KW KWS1349DS SWX703HQ
FTW3014KW MWS939AS SWX703HS
FWS1233FS SWS1233HQ WWS833FS
FWS933FS SWS1233HS WWTW3000KW
GLWS1439FC SWS1339HS
GLWS1439FS SWS1649HS
XC90306228 to XC91606302
Front Load Washer Crosley, Frigidaire, Wascomat,
White- Westinghouse
CFW2000FW FTF530FS WE17N
FCCW3000FS GLTF1570FS WTF330HS
FTF1240FS WE17M
XC90501765 to XC91607678
Laundry Center Crosley, Frigidaire, Kenmore,
White -Westinghouse
97812 CLCE900FW GLET1142FS
97912 FEX831FS GLGH1642FS
97962 FGX831FS GLGT1031FS
C97812 FLGB8200FS GLGT1142FS
C97912 GCET1031FS MEX731CFS
C97962 GLEH1642FS SWSG1031HS
CLCE500FW GLET1031FS SWXG831HS
XE85104013 to XE91603486

*Not all serial numbers within these ranges are affected.

Model and serial numbers can be located as follows:

Top load washer = open the product’s lid, and the model and serial number are located inside the product’s lid, on the top, right hand corner.

Front load washer = open the door, and the model and serial number are located with other information at the top, center.

Laundry center = open the door to the dryer, and the model and serial number are located on the outer edge of the door nearest the door’s handle.

Sold by: Sears and other retailers nationwide from February 2009 through May 2009 for between $300 and $1100.

Manufactured in: United States

Remedy: Consumers should immediately unplug and stop using the machine. Consumers should contact Frigidaire or Sears (if unit was purchased there) to schedule a free repair.

Consumer Contact: For additional information, contact Frigidaire at (800) 734-4519 between 8 a.m. and 11 p.m. ET Monday through Saturday, or visit the firm’s Web site at www.laundrypumprecall.com. For consumers who purchased their product at Sears, call Sears toll free at (888) 549-5870 between 8 a.m. and 10 p.m. ET Monday through Saturday, or visit Sear’s Web site at www.sears.com

More information: http://www.cpsc.gov/cpscpub/prerel/prhtml09/09292.html